- How to adjust the water level for a partial or full flush?
Use the Red float for full flush adjustment and the Gray for partial flush adjustment. The Maximum and minimum levels are shown on the graduation up or down.
- How to fix the button in the flush valve standing out?
It may be caused during transportation. Simply, push the button down.
- The seal gets dirty so it makes the flush valve not close up 100%.
Clean up the seal
- What do I do if there is a visible gap between the flush valve body and its base?
There are two buckles in the flush valve body to lock the flush valve body and its base, when one is well locked and one is unlocked, it will cause leaking. Well lock the two buckles and make no gap between the flush body and the base.
Articles in this section
- How Do I Install Or Replace A Cartridge?
- How Do I Install Or Replace The Diverter For My Faucet?
- How Do I Remove or Install The Handle For My Faucet?
- Adjusting Temperature Limits of Gerber G0092298 / Danze A507694N Ceramic Disc Cartridge with Limit Stop for Single Handle Lavatory and Kitchen Faucets
- Danze by Gerber D112000, D113000, D115000 Valves - Back to Back or Reverse Hot / Cold installation
- Defining a Good Flush from a Toilet
- How do I clean the toilet, toilet seat and bowl rim holes?
- How Do I Install A Ceramic Disc Cartridge For A Roman Tub Faucet?
- How Do I Install A Ceramic Disc Cartridge For A Single Handle Kitchen Faucet?
- How Do I Install A Compression Cartridge For My Two Handle Tub / Shower Faucet?
- See more
Comments
Please sign in to leave a comment.