- Remove the lid from the tank
- Shut off the water by turning the shut-off valve clockwise
- Drain as much water out of the tank as possible by holding the flush lever down until the toilet is completely flushed.
- Sponge or towel out any remaining water in the tank. A shop vac also works well.
- Disconnect the water supply tube or hose that connects the water supply valve to the fill valve
- Beneath the tank, loosen the lock nut that holds the fill valve to the tank.
- Remove the old fill valve.
- The new fill valve will go on similarly to how the old one came off.
- Reattach the new fill valve and adjust the float to connect height according to the manufacturer's instructions.
- Attach a new refill tube to the overflow pipe
- Reattach the water supply tube or hose to the tank
- Turn on the water, test the new fill valve and check for leaks
Articles in this section
- How Do I Install Or Replace A Cartridge?
- How Do I Install Or Replace The Diverter For My Faucet?
- How Do I Remove or Install The Handle For My Faucet?
- Adjusting Temperature Limits of Gerber G0092298 / Danze A507694N Ceramic Disc Cartridge with Limit Stop for Single Handle Lavatory and Kitchen Faucets
- Danze by Gerber D112000, D113000, D115000 Valves - Back to Back or Reverse Hot / Cold installation
- Defining a Good Flush from a Toilet
- How do I clean the toilet, toilet seat and bowl rim holes?
- How Do I Install A Ceramic Disc Cartridge For A Roman Tub Faucet?
- How Do I Install A Ceramic Disc Cartridge For A Single Handle Kitchen Faucet?
- How Do I Install A Compression Cartridge For My Two or Three Handle Tub / Shower Faucet?
- See more
Comments
Please sign in to leave a comment.